Float Switch – 10 Metres Cable, 0.46 mm² (0.50 mm² nominal)

Detailed Description:
This float switch comes with a 10-metre long cable, with conductors of approximately 0.46 mm² (nominally around 0.50 mm²), making it suitable for installations where a long reach is required (deep tanks, remote sumps, long drops). The device detects rising or falling liquid level via the float actuator and triggers an electrical contact (typically normally-open or normally-closed or changeover) for pump control, alarm function or level monitoring.

Key Features:

• Cable length: 10 metres — supports deeper or remote placement of the float assembly.

• Conductor size: ~0.46 mm² (≈0.50 mm² nominal) — adequate for typical control-circuit current/voltage in level-switching scenarios (confirm your circuit conditions).

• Float actuator/sensor: Durable construction (material depending on model—e.g., polypropylene or stainless steel) suitable for water or compatible liquids.

• Switch output/contact: Typically available as NO (normally open), NC (normally closed) or changeover (SPDT) depending on variant.

• Applications: Ideal for level-control in tanks, sumps, cisterns, wastewater pits, remote installations in industrial or domestic contexts; used for pump start/stop, overflow/high level alarms, low-level cut-offs, general fluid-level detection.

• Installation guidance: The float must have freedom to rise/fall without obstruction; route the 10 m cable with suitable strain relief; check the fluid, ambient temperature, environment (e.g., chemical presence) and mounting orientation.

• Electrical/environmental remarks: Ensure the switch’s voltage and current ratings suit your system; cable length adds potential for voltage drop or interference—good practice to verify wiring run, insulation, environment (outdoor vs indoor) and protective measures.